Part 1: How to Mix (Reconstitute 10mg/10mg blend vial)
- Add 2 mL (200 units) of bacteriostatic water to your blend vial.
- Slowly push the needle into the powder vial. Aim the needle at the glass wall and press the plunger slowly so the water trickles down.
- Dissolve: Gently swirl the vial in circles until the liquid is completely clear. Do not shake it like a cocktail shaker, as rough shaking can damage the peptides.
- Store: Put the mixed vial straight into the refrigerator. It must stay cold.
Part 2: Dosing & Schedule
Because the peptides are blended in a 1:1 ratio, pulling to your target unit mark delivers the correct amount of both simultaneously:
- Starting Dose (5 units): Pull to the 5-unit mark on your syringe.
- Selank: 250 mcg (0.25 mg)
- Semax: 250 mcg (0.25 mg)
- Increased Dose (10 units): If the starting amount is well tolerated, the dose can be increased to the 10-unit mark.
- Selank: 500 mcg (0.5 mg)
- Semax: 500 mcg (0.5 mg)
- The Schedule: This protocol can be administered on an as-needed basis depending on your specific requirements.
- The Daily Cycle: If choosing to follow a consecutive daily dosing protocol, run it for 2 weeks on, followed by a 1 week break before starting the next cycle.
Part 3: How Long It Lasts
- Total Liquid: 2.0 mL = 200 units total.
- Vial Lifespan: Your total vial life depends on your chosen dosage tier:
- At 250 mcg each (5 units): This setup gives you exactly 40 total doses per blend vial.
- At 500 mcg each (10 units): This setup gives you exactly 20 total doses per blend vial.
- Timeline: If utilizing the consecutive daily protocol at the starting dose, a single vial provides 40 days of dosing. Because of the required 1-week breaks every 2 weeks, it will stretch to cover roughly 2.5 total months of calendar time. At the higher 10-unit dose, it will cover 1.3 months of calendar time.